BAR-HARNESS BLUE 32" WIDE CD1

Description

The Original Bar Harness was invented in 1993 to solve the problem of where to attach tie-downs to a motorcycle covered in plastic body work

Made entirely of polyester webbing and sewn with polyester thread

A hassle-free way to secure motorcycles for transport

Nylon webbing has tensile strength of over 5500 lbs.

Fits bars up to 28" wide

Red

Warning: NEVER start engine with harness installed. NEVER install harness on loose bars. NEVER install harness on any part of the motorcycle except the grips at the ends of the bars. NEVER install harness on handlebars higher than four inches above the top triple clamp or handlebar clamp. NEVER compress the front forks more than half way, or approximately two to three inches. NEVER pull down on the straps hard enough to bend your handlebars. NEVER install harness on motorcycles with extended forks (such as choppers).

Specifications

Magnuson-Moss Warranty Act

Legally, a vehicle manufacturer cannot void the warranty on a vehicle due to an aftermarket part unless they can prove that the aftermarket part caused or contributed to the failure in the vehicle (per the Magnuson Moss Warranty Act (15 U.S.C. 2302(C)).

California residents

WARNING: This product can expose you to chemicals including nickel, which is known to the State of California to cause cancer. For more information go to www.P65Warnings.ca.gov.